Sound Deadener Sheets - 6 Sheets

Self adhesive sound deadening sheets with aluminum foil heat shield

Size: 300mm x 300mm per sheet
Pack size: 6 Sheets per pack
Total area coverage: 600 x 900mm

Coverage:  0.54 Sq Mtrs / 5.82 Sq Ft
Thickness: 2mm
Packaging: Heat sealed blister and card with 3 hang holes
Weight: 1.57kg Per pack

INSTALLATION
1. Remove interior upholstery, trims or carpet.
2. Remove loose debris, dirt and grease to ensure sound deadener is stuck to a clean surface.
3. Cut DNA Designer Audio Sound Deadener to desired size. Be sure to allow for door trim plugs and clips to be re-fitted. Do not cover mechanical devices, wires and drain plugs.
4. If the weather is less than 18°C heat will need to be applied. For optimum results apply heat to ensure maximum adhesion.
5. Peel off the backing sheet. Bend the mat slightly and attach the short edge.
6. Slowly and firmly roll into position using a roller. Be sure to remove and air pockets obtaining strong bond to the metal work.

Recommended Installation Location
Doors:
Inner & outer skin to reduce road noise and improve musical mid bass and mid range vocals produced by door speakers
Boot:
Lid floor, quarter panels, rear deck, wheel wells to reduce road noise, exhaust drone as well as increasing subwoofer SPL and clarity.
Floor:
Cover the entire floor including under seats to reduce road noise, engine noise, exhaust and resist heat. This will enhance your current audio system sound quality.
Roof:
To reduce wind noise, radiant heat and eliminating vibrations from the audio system and increasing subwoofer SPL and clarity.
Firewall:
To reduce engine noise, road noise and dissipate heat.

Also available is the WHD400 sound deadener pack.
7 x WHD102 works out to be about the same size as WHD400.